Page 1 of 1

PS2 Mouse not working during installation

Posted: Fri Jun 03, 2016 10:45 pm
by kudo2002
Hi, I'm new here

And got small question about PS2 mouse while installing El Capitan 10.11.5

Note:
I did try USB mouse it doesn't work also tried some usb fixes like El Capitan USB V3

my Rig:
FX-8350 blackEdition
GA-990FXA-D3
Gigabyte GTX 580
DDR3 12GB 1866

Re: PS2 Mouse not working during installation

Posted: Fri Jun 03, 2016 10:48 pm
by Shaneee
Install these kexts either to Extra/Extensions or System/Library/Extensions depending where you installed FakeSMC ect and boot with UseKernelCache=No

Re: PS2 Mouse not working during installation

Posted: Fri Jun 03, 2016 11:23 pm
by kudo2002
Stuck on looping message "AppleUSBEHCI .... as expected", can't get any further

Re: PS2 Mouse not working during installation

Posted: Sat Jun 04, 2016 11:46 am
by kudo2002
Fix the last problem by using Shanee USB fix and my ps2 mouse didn't work after all
I succeeded to install El Capitan 10.11.3 once it reboot it doesn't boot to the system, it just reboot on loading drivers
Please help

Re: PS2 Mouse not working during installation

Posted: Sat Jun 04, 2016 12:51 pm
by gazza35
Nvidia Gfx Card by any chance??, ive experienced same issue, try - GraphicsEnabler=No, its also always wise to use Verbose boot mode, -v, just to get an idea of where the problem occurs, as for usb mouse and El Cap, thats common due to changes made in USB architecture, theres plenty of fixes for that, of which only a couple work, stick to the ones on here.

Re: PS2 Mouse not working during installation

Posted: Sat Jun 04, 2016 12:59 pm
by Shaneee
@kudo2002, Where did you put the PS2 kexts? Also you need to follow this tutorial after installation to allow it to boot, viewtopic.php?f=24&t=80

Re: PS2 Mouse not working during installation

Posted: Sat Jun 04, 2016 2:41 pm
by kudo2002
Shaneee wrote:@kudo2002, Where did you put the PS2 kexts? Also you need to follow this tutorial after installation to allow it to boot, viewtopic.php?f=24&t=80
AppleACPIPS2Nub.kext
ApplePS2Controller.kext

in the Same folder with my FakeSMC.kext

which is in Extra/Extensionsfolder

Re: PS2 Mouse not working during installation

Posted: Sat Jun 04, 2016 4:57 pm
by kudo2002
Finally after applying Post Installation I was able to see Select Language Page from Apple, but No Usb mouse + Keyboard + PS2 mouse all dead

Re: PS2 Mouse not working during installation

Posted: Sat Jun 04, 2016 6:17 pm
by kudo2002
I ran to another problem which happened after apply Shanee usb fix
"invalid B-Tree"
Shutdown after 3 seconds

Re: PS2 Mouse not working during installation

Posted: Sat Jun 04, 2016 7:09 pm
by Shaneee
How did you apply the fix? If you've done this from Windows with a 3rd Party Application it has most likely damaged the partition table and you will need to recreate the USB.

For PS2 you can also try this kext,
Code: Select all
https://bitbucket.org/RehabMan/os-x-voodoo-ps2-controller/downloads/RehabMan-Voodoo-2016-0529.zip